Thermo-shaping Unit
The thermo-shaping unit from Brisay is used to shape plastic pipes and hose lines (PA plastics) rapidly and reliably in 2D/3D geometry through changes in the molecular structure. Shaping is carried out with heat by applying steam; the subsequent cooling is done with cooled water. The part is then dried with compressed air. This technologically new development ensures cost-effective shaping and setting of pipes and lines.
Various sizes of different materials can be processed simultaneously
The thermo-shaping machine is equipped with 3 registers each with connections. Registers may be operated at the same time with different process parameters.
- Temperature probes are used to measure and control the temperature
- A filter unit (4 μ) is installed in the water circulation to remove dirt particles from the cooling water.
- The process flow is controlled by an automated control system.
- Weight 1278 lbs; 230 V; 0.5 kW; WxLxH 122,1x1420x1680 inch
Peripheral equipment
The thermo-shaping unit works in combination with a water treatment unit, a steam generator, an air compressor and a cooling unit.
The hose unwinding device
Allows the energy supply hoses which are inside the base unit of the thermo shaping machine to be positioned anywhere on the work surface and connected to the corresponding pieces to be shaped.
The production cycle consists of the following steps:
- Preparing: Place plastic pipes or hose lines 1 into the customers shaping appliance 2 and use the innovative rapid exchange system to connect them to the thermoshaping machine.
- Steam supply: for heating and shaping:
- Compressed air supply: For blowing out water and drying.
- Deferred compressed air supply: For dry blowing of hoses, which are not used.
- Removal: Release rapid exchange systems and remove plastic pipes or hose lines from molding appliances.
