Grid Plates

BRISAY ironing machines are equipped with an elaborate cover system which has been optimized over decades. This cover system ensures optimal ironing results. However, the life span of such a cover is limited, so after three to six months, the buck cover should often be renewed.

In many production plants, fitting the cover constitutes a problem:

• Quality problems. If staff is not adequately trained, the combination of the varoius layers of the cover system will not be correctly fitted leading to bad
pressing results.

• Extra hours. Covers must be fitted out of production hours, thus

requiring technicians to work overtime

• Cost of cover materials

• Decreasing quality. Material fatigue starts already after approximately

half the cover’s life span

• Duplicate work. When fixing the cover or cleaning the fine wire mesh, marks may be caused which are then difficult to remove. Often, the wire mesh has to be replaced entirely, thus causing additional costs and extra working hours

You will cut costs due to:

• Long life span – minimum of five years (at 600 pcs/day and adequate use)

• KD plate can be reprocessed and recoated

• Within 30 minutes, you can exchange your old cover against the new KD plates

• No modification of machine required

Improved quality through:

• Mistakes in the combination of the varoius layers of the cover system and thus bad pressing

results are avoided

• Special shape: homogenous finishing results; equal pressure at any point of the form

• Special “sandwich” structure. The structure of the intermediate layer of the KD plates ensures a more homogenous distribution of steam, compressed air and vacuum as compared to standard covers.

• No marks. Marks are avoided because there is no uncontrolled evaporation of steam.

• Unlike with regular covers, there is no Moiré effect when using KD plates.

• Most garments can be ironed to a higher degree of dryness